Fully automatic soldering machine will surely understand many aspects of knowledge in the preliminary introduction of Xiaobian, but today Xiaobian wants to tell everyone about the problem is related to some specific knowledge points. Today, for everyone to answer the following questions about how to adjust the automatic soldering machine to solder the data line? First, it is worth noting that we generally look at the product, but also do fixture positioning, and then welding, welding wire products A variety of different degrees of difficulty, automatic soldering machine to help you free debugging, free help you solve the solder problem. Data cable automatic soldering machine production line is also to see you the type of automatic soldering machine:

1, using multi-head automatic soldering machine for welding data lines

The method is to use a PLC to control 4 to 8 soldering irons at the same time to weld at the same time, so that one or two products can be produced by welding one point. The premise is also to do a good job of the product fixtures in advance, there must be a lot of people to the front section of the line. Its characteristic is that the welding speed is fast, the welding quality is high, can save the manpower greatly.

2, using a single automatic soldering machine for welding data lines

The method is to use the current automatic soldering machine to carry out welding. We do a good job of fixtures in advance, fix the USB to the fixture, and then put it together with the fixture on the automatic soldering machine for welding, a fixture can be placed on a variety of products , such a person can basically operate a machine. Its characteristic is that the welding quality is relatively good, the output is also OK, probably can weld a point about 1 second.

3, using hot pressure welding data lines

The so-called hot press for welding is the common type of hot press. It is a head down at the same time. Four solder joints are welded at once. At present, people use this method, but it is not very mature. The main reason is that the quality of welding products cannot be guaranteed, and the defective rate is relatively high. Its characteristic is one-time investment is small, welding is fast, but the defective rate is relatively high.

Above is the automatic soldering machine manufacturers for everyone to sum up to 3 points is how to adjust the automatic soldering machine to weld the data line specific aspects of the measures, I hope everyone in the automatic soldering machine can get a corresponding understanding of this issue.