Ionic wind bar is widely used in packaging and printing industry because of the special strip shape design and electrostatic dust removal principle; all kinds of sheet material processing; slitting processing, winding processing and rough surface irregular objects and manpower inaccessible environment In addition to electrostatic dust removal.

However, the ion wind bar needs to be installed and used in strict accordance with professional requirements. It must also be maintained and maintained when it is used. Otherwise, click accidents can easily occur.

Ionic wind bar installation and use methods:

1. Ionic wind bar should be used together with high voltage power supply;

2. Insert the end of the wind bar connector into the high voltage output jack of the high voltage power supply and turn it clockwise until it reaches the end;

3. Connect the ground wire of the wind bar connection to the grounding column on the outside of the high voltage generator and confirm that the grounding is good;

4. Insert the plug of the high voltage generator into the socket with grounding wire (note the voltage of the high voltage generator);

5. The wind bar is fixedly installed in a suitable position, and the high voltage generator power supply is turned on to work.

Ionic wind bar use matters needing attention:

1. The discharge pin of the ion wind bar should be far away from the metal mounting bracket of the wind bar. It is better to use insulating material as the bracket.

2. In order to allow the material to be charged with enough static electricity, there must be a flat metal plate or metal mesh plate on the back of the electrostatically charged material. This metal pallet is connected to the ground, the working ground of the DC high voltage supply, so that the electrostatic discharge can form a loop.

3, in order to make the material can be added enough static electricity and static electricity will not leak (run away) quickly. The greater the required material insulation value, the better. The drier the material and the ambient air, the better.

4. It is better not to discharge electrostatic discharge needles against bare metal trays. That is, the area of statically charged material is equal to the area of metal trays. If the material to be static electricity is changed due to the size of the area, and the area or length of the static emitter cannot be changed, then it is better to put a thicker insulator on the bare metal tray or cover it with bare light. The discharge needle of the pallet tries to cover it, which helps the charge to concentrate on the material that needs to be charged.

Ionic wind bar operation safety matters:

1. The socket that connects the high voltage power supply must be grounded reliably.

2. Do not use under flammable environment.

3. Do not repair by yourself.

Ionic wind bar daily maintenance and maintenance:

1. Turn off the high voltage power supply when not using an electrostatic stick.

2. The ion needle is cleaned once every six months. Turn off the power when cleaning. Use a cotton swab to gently scrub the ion needle inside.